Voltage Influenced LFO is a unique module in the world of modular systems. This is a very unusual low frequency oscillator. The module has two outputs: "TRI" is a triangular wave (basic for the module)."VAR" is a variable wave that goes from the triangle...
Analog delay module, built on two chips 4096 BBD (Bucket Brigade Delay line). It is the predecessor of Analog Replicator. Rate sets the delay time, FBK - the feedback intensity, DRY - the volume of the original signal at the output, WET - the value...
Waveforms Oscillator is the analog oscillator (VCO) with multiple outputs and the possibility of modulation. Waveforms is designed to work with 1V/octave signals, and notes can be played within five octaves. Unlike vintage VCO, the module has good...
The module consists of three independent function blocks: Glide - the limiter (or portamento, or lag-processor). The "TIME" knob adjusts the rise time of the signal.Sample & hold - contains an analog noise generator and a sample&hold circuit. The...
Synthesizer Box is a semi-modular analog synthesizer in the Eurorack format. It is very suitable as the prime modular synthesizer: all basic connections are already routed – “plug and play” kind of thing. All the main function blocks have their...
The module is designed for routing and mixing audio and/or control signals. Each of the four channels can be manually switched by the on/off switch or by the control signal received by the Gate In. The signal sent to the input can be sent to bus A and/or...
The sequencer can play sequences of 4, 6 or 8 steps (depends on the position of the switch). In order to move from step to step, the timing signal routed to the "CLK" input can be used. It can be a square wave or a gate signal. For the construction of...
The Phase Shifter module is an analogue 16-step phaser. In addition to the output at the sixteenth stage, there’s another mix (dry/wet) is provided after the eight one. In addition, there are outputs after the seventh and fifteenth steps which allow no...
The module is designed as an "extreme" block of the modular system, its purpose is to output the generated synth sound. Outs has two independent inputs, which allows the module to be used not only as a stereo, but as a dual mono. If the signal cable is...
Oscillator v2 is a compact analog voltage controlled oscillator (VCO). It is built on the same principle as its big brother was. The module is controlled by a 1-volt signal per octave and can play notes within a 5-octave range. A coarse and fine tuning...
