c cortirovkoy cost {most expensive first}
Oscillator v2 is a compact analog voltage controlled oscillator (VCO). It is built on the same principle as its big brother was. The module is controlled by a 1-volt signal per octave and can play notes within a 5-octave range. A coarse and fine tuning...
The analog module based on a resistive optocoupler is designed to simulate the characteristics of natural instruments (violins, wind instruments, guitars, etc.). It is known that natural instruments tend to change the harmonic composition depending on...
Analog multifunctional voltage-controlled filter, based on SVR (State Variable Filter) technology. It has four filters with individual outputs: low pass, band pass, high frequency (high pass) and a notch filter. Notch filter can have the characteristic...
Crush is an analog bitcrusher, an effect that simulates the degradation of a signal when the sample rate decreases. The effect is based on the quantization of a signal with a specified frequency, which is set manually or via CV input. The ratio of the...
The module serves to expand the capabilities of the Generator. 2 ribbon cables connect the modules (included in the delivery). Genexpander provides four functions: Waveshaper - designed to convert waveforms. A simultaneous generation of triangular and...
Voltage Influenced LFO is a unique module in the world of modular systems. This is a very unusual low frequency oscillator. The module has two outputs: "TRI" is a triangular wave (basic for the module)."VAR" is a variable wave that goes from the triangle...
Envelope is an analog function generator which can be used in a variety of ways: attack-decay (AD) envelope, attack-sustain-release (ASR), attack-release (AR), LFO, output voltage limiter, wave shaper. The attack time is set by the regulator or an...
There are two high-quality linear VCAs (voltage controlled amplifier) in the module. For each of the VCA, a separate control input with an adjustable attenuator and a passthru are provided. The presence of a mix output allows the module to be used as a two-channel controlled mixer.
The module consists of three independent function blocks: Glide - the limiter (or portamento, or lag-processor). The "TIME" knob adjusts the rise time of the signal.Sample & hold - contains an analog noise generator and a sample&hold circuit. The...
The sequencer can play sequences of 4, 6 or 8 steps (depends on the position of the switch). In order to move from step to step, the timing signal routed to the "CLK" input can be used. It can be a square wave or a gate signal. For the construction of...
