The module is designed for routing and mixing audio and/or control signals. Each of the four channels can be manually switched by the on/off switch or by the control signal received by the Gate In. The signal sent to the input can be sent to bus A and/or...
239.00
The sequencer can play sequences of 4, 6 or 8 steps (depends on the position of the switch). In order to move from step to step, the timing signal routed to the "CLK" input can be used. It can be a square wave or a gate signal. For the construction of...
149.00
The Phase Shifter module is an analogue 16-step phaser. In addition to the output at the sixteenth stage, there’s another mix (dry/wet) is provided after the eight one. In addition, there are outputs after the seventh and fifteenth steps which allow no...
369.00
The module is designed as an "extreme" block of the modular system, its purpose is to output the generated synth sound. Outs has two independent inputs, which allows the module to be used not only as a stereo, but as a dual mono. If the signal cable is...
99.00
Oscillator v2 is a compact analog voltage controlled oscillator (VCO). It is built on the same principle as its big brother was. The module is controlled by a 1-volt signal per octave and can play notes within a 5-octave range. A coarse and fine tuning...
199.00
