Lower or upper part for building up an 18 panel system 200e. It does not have its own power supply, therefore it is necessary to connect it to the "active housing" (201e-6 Powered Boat) to make the modules operate.
The central part for building up an 18 panel system 200e. There is a power distributor onboard, the power unit itself is external. The switched mode power supply 12V comes with a set of adapters for working with any standard of networks (USA, Europe, Japan).
Lower or upper part for building up a 12 panel system 200e. Accomodates up to 4 modules. This case is mountable in a standard 19" rack. It does not have its own power supply, therefore it is necessary to connect it to the "active housing" (201e-4 Powered Boat) so that the modules could operate.
201e-4 is the central part for building up a 12 panel system 200e. Can accommodate up to 4 modules. There is a power distributor onboard, the power unit itself is external. The switched mode power supply 12V comes with a set of adapters for working with...
297 module is assembled according to an analog circuit and is not a representative of the "e" family. It represents the classic phase shift effect with advanced tuning and modulation capabilities. The module is divided into seven sections: Input section,...
296e is a 16-channel band pass filter with built-in eight-step spectral analyzer. The module can be used as a 16-channel VCF, a composite equalizer and a spectral vocoder. Each channel has an independent voltage-controlled amplifier with a control input...
292h is a two-channel equivalent of Buchla 292e, which has almost the same functionality. The difference from the older model lies in the smaller number of channels and the absence of the morph mode. Each channel can work in VCF, VCA mode or combine...
Buchla 292e is a multifunctional module that can be used as a voltage controlled amplifier (VCA), a controlled filter (VCF) or a mixer. Switching the operating mode of each of the four channels is managed with a button. Available modes: Low-pass is a...
The module contains three voltage-controlled band pass filters, which can work independently or in parallel. Each filter provides the ability to adjust the filter's steepness, center frequency and bandwidth. All the main parameters of each filter can be...
The frequency shifter and balanced modulator are two independent functional units integrated in the Buchla 285e housing. Frequency Shifter is designed to shift the input signal to an arbitrary frequency. The offset frequency can be set from the internal...
